CCWB is unique in that it is a solution of polymers in water. Other water based CP’s are dispersions that have a milky, opaque appearance. CCWB is clear from the moment it is put onto the thread, with no cloudiness or hazing as can be seen in other products. CCWB is recommended for all thread except for Silk. For Silk the original Crystal Clear is recommended.
Apply two coats of CCWB full strength to the thread wraps, allowing each coat to dry thoroughly. When first applied there will be a significant darkening of the thread, particularly when applied to Madeira thread. This is normal. Simply allow each coat to dry thoroughly before proceeding to the next step. When the CCWP first dries you may see a slight haze form on the surface of the thread. Don’t panic. This haze disappears when Epoxy Finish is applied.
CCWB should be applied in multiple light coats, taking care to not flood the wrap with the product. If the product is applied too heavily then the white haze that develops (again, this is normal) can become a problem. In addition, CCWB is meant for application to the thread, not the bare blank. If for some reason color preserver is needed on a bare blank (perhaps to protect a decal or an inscription) then the original formula is recommended.
It is recommended that this product be used full strength. If you wish to dilute this product use de-mineralized water with a small amount of household ammonia added. However, dilution increases the number of coats needed to achieve full protection. 50% dilutions will double the number of coats necessary to assure adequate protection.
Do not speed up the drying process with a heat gun or a hair drier. This can cause the polymers to crystallize into a glass-like form that can affect the color of the thread. It is also likely to blow dust onto your artwork. If you wish to speed up the drying process then simply keep the workspace warm and dry, or in the alternative place the section of rod into a heated drying box.
Do not apply CCWP so heavily that it puddles. If that occurs then use your brush to wick the excess material from the thread. If bubbles form during application then dip the brush that is filled with CP in water and lightly touch any bubbles. This breaks the surface tension and allows any such bubbles to pop.
Shopping Cart
